
We Come To You!
Our mobile tyre fitting service is your convenient solution
Need a tyre in Thornbury?
Tell us your tyre size and where you are — we quote before we set off.

Areas We Cover
Drivers across England and Wales — maximum 60 minute response
Popular Tyre Brands Available
We supply & fit new, high-quality and branded tyres for all major vehicles









See what our customers think
Browse through our customers testimonials.
Mobile Tyre Fitting in Thornbury
Thornbury, Oldbury and the Severn shore — 24 hours a day.
Maximum 60 minute response. We have drivers across England and Wales, so a call gets a fitter to the vehicle rather than you moving a car that is not safe to move. Call 07989 606060 with your tyre size and location.
Thornbury is an old market town on the slope above the Severn, with a castle at the top and the estuary flats a couple of miles west. M5 junction 14 is just north of it.
Roads and places we get called to around Thornbury
- The B4061 through the town and down to the A38.
- M5 junction 14 and the A38 corridor.
- The High Street, Castle Street and the church end.
- Oldbury-on-Severn and the site road down to the old power station.
- The warths and the lanes out to Littleton and Aust.
The warths
Between the villages and the water the ground is reclaimed saltmarsh — locally the warths — kept behind an earth bank. The lanes across it are single track, unlit, and lower than the fields beside them in places.
Two things follow from that. Verges out there are silt rather than hardcore and will not hold a jack; and when the Severn runs high the water sits on those lanes long after rain has stopped. The estuary has a very large tidal range and a high spring tide will do it without any rain at all.
Salt air is the other consequence of being this close to the estuary. Steel wheels corrode where the rim meets the tyre and a wheel that has sat for years will often need the sealing face cleaning up before anything holds pressure.
The old town
Castle Street and the top of the High Street are narrow, listed and lined with parked cars on both sides. There is often no width to work in and no lawful place to put a van either.
The car parks behind the High Street are a far better meeting point if the car can still be moved. Say on the phone whether it can — it changes what we plan for.
The Oldbury site
The old power station at Oldbury is under decommissioning and the road down to it is a controlled approach rather than a public route. We can attend, but it needs arranging in advance through the site rather than at the gate.
We also cover Bristol down the A38 and Gloucester up the M5.
What we can do in Thornbury
- Mobile tyre fitting — supply and fit a replacement at your home, workplace or the roadside, including balancing and disposal of the old casing.
- Mobile puncture repair — where the damage is inside the repairable area of the tread, a repair is cheaper and quicker than replacement.
- Commercial tyre fitting — vans, minibuses and other light commercial vehicles.
Stuck in Thornbury right now? Call 07989 606060 and we will tell you what we can do and what it will cost before we set off.
Before we arrive
- Find your locking wheel nut key. Without it the wheel cannot come off. It is usually in the glovebox, the boot well, or with the spare.
- Read your tyre size off the sidewall, for example 205/55 R16 91V, so we arrive with the right tyre rather than making a second trip.
- If you are on a motorway or dual carriageway, get as far left as you can or into a refuge, then everyone out through the passenger doors, over the barrier and well back from the carriageway — not in the car. Ring with the junction number and your direction of travel.
- Describe where you are, not just your postcode. A junction number, a bay number, a farm, a pub or a bridge puts us on the spot far faster — rural postcodes can cover a mile of near-identical lane. We bring our own lighting, so darkness is not a problem.
More detail in our guides on what to do with a flat tyre on the motorway and checking your tread depth.
Repair or replace
Whether a tyre can be repaired is decided by where the damage is, not by how big the hole looks. Damage inside the central three-quarters of the tread, up to 6mm across, is repairable under BS AU 159. Damage in the shoulder or the sidewall is not, at any size — there is no way to reinforce a sidewall that flexes on every revolution.
The other thing that rules out a repair is having driven on the tyre flat. A short distance is enough: the sidewall folds under the rim and the internal cords break. That often does not deflate the tyre at the time — it shows up days later as a soft rounded bulge, and a tyre in that condition has to be replaced whatever the original puncture looked like.
How the damage was made matters as much as where it is. A nail or a screw pierces, leaving a neat hole that is usually well within the limit. Flint, crushed stone, quarry aggregate and dropped stainless fixings cut instead — a gouge or a tear rather than a puncture — and a cut frequently exceeds the repairable size even when it lands squarely in the middle of the tread. That is why we take the tyre off and look inside before telling you either way, rather than judging it from the outside.
Impact damage behaves the same way. A pothole or a kerb taken at speed compresses the suspension fully and pinches the sidewall between the rim and the obstacle. If that has happened, check both tyres on that side — the rear takes the same hit a fraction of a second after the front — and look for a bulge rather than for a hole.
We carry both outcomes to every job, so a repair that turns out not to be safe does not become a second visit.
Age and wear
Tread depth is not the only thing that retires a tyre. Rubber hardens as it ages whatever the mileage, which is why a caravan, motorhome, trailer or second car can carry almost full tread on a casing that is well past useful life. The four-digit date code on the sidewall gives the week and year it was made — our guide on how long tyres last covers where the line falls.
Depth matters most in standing water. The legal minimum is 1.6mm across the central three-quarters, but a tyre's ability to clear water falls off well above that — by about 3mm you are losing it noticeably, and aquaplaning starts at lower speeds than most drivers expect. Our tread depth guide covers checking it with a 20p coin in about a minute.
Wear patterns are worth reading too. Both outer shoulders going before the middle usually means underinflation, or a lot of cornering and hill descent; one edge alone is more often alignment. We will tell you which it looks like when we are there — see uneven tyre wear for the full picture.
Vans and light commercials
A van needs a tyre carrying the C marking and the correct load index. That is not interchangeable with a passenger tyre of the same nominal size, whatever may have been fitted before — the casing is built to carry more, and a loaded van on passenger-rated tyres is running outside the rating.
Tell us whether the van is loaded when you ring, and we will bring the right fitment first time. Details of what we carry are on the commercial tyres page.
How the repair is done
The wheel comes off, the tyre comes off the rim, and the inside of the casing is inspected before anything else happens. The puncture is then repaired from within using a combined plug and patch, and the wheel is balanced before it goes back on.
That inspection is the part that matters. An external plug pushed into the tread without removing the tyre is a get-you-home measure: it can seal the hole while leaving damage inside the casing entirely undetected, and that damage is what causes tyres to fail later at speed. It is the same job a garage does, done where the vehicle already is.
A slow leak with no puncture to find
A tyre that loses air over days with nothing in the tread has usually failed at the seal rather than the surface — a corroded alloy bead seat, or a perished valve stem. Neither can be found with the tyre still on the rim, and neither is fixed by topping the pressure up.
It typically announces itself on the first cold morning of the year. Cold air contracts, dropping the pressure a few PSI, and a leak that was tolerable through mild weather is a visibly flat tyre by the time you come out to the car. The fix is the tyre off the rim, the sealing face cleaned back to sound metal, and a new valve.
Working conditions around Thornbury
Standing water. We will not drive a van through water of unknown depth, so if a road is flooded we may ask to meet you on higher ground. Tell us which road you are on when you ring and we will work out the approach before setting off rather than after.
Lanes and farm access. Single-track lanes need somewhere to put both your vehicle and ours without blocking the road, so a gateway or a passing place is worth reaching if the car is still drivable. Agricultural traffic drops wire, staples and broken tines, and harvest spreads them well beyond the field gate — which is why the lanes produce punctures out of proportion to how little traffic they carry.
Narrow and historic streets. Older centres combine tight streets, limited parking and setted or cobbled surfaces. A jack needs a flat, firm, continuous base and setts rock under load, so we will usually ask to move a few yards onto smooth tarmac. If there is not a car's width beside the wheel, tell us when you ring and we will sort out where to meet instead of finding out on arrival.
Common questions in Thornbury
- Will a warth lane verge take a wheel?
- Better not to. Those verges are estuary silt rather than hardcore and will not carry a jack, let alone a wheel.
- The lane is under water and it has not rained.
- That will be the tide. The Severn's range is large enough that a high spring tide floods the low lanes on a dry day.
- My alloy leaks slowly and there is no nail in it.
- Salt air corrodes the rim where the bead sits. We break the tyre down, clean the sealing face back to metal and reseat it.
- Castle Street is too narrow for you to park.
- Usually, yes. If the car still moves, one of the car parks behind the High Street is a much better meeting point — tell us on the phone which way you can go.
- Do you cover Alveston, Olveston and Falfield?
- Yes, across BS32 and BS35.
Not in Thornbury?
We cover the rest of Gloucestershire and beyond. If you are closer to one of these, the same service and the same number applies:
- Mobile tyre fitting in Cheltenham
- Mobile tyre fitting in Cirencester
- Mobile tyre fitting in Dursley
- Mobile tyre fitting in Gloucester
- Mobile tyre fitting in Stroud
- Mobile tyre fitting in Tewkesbury
- Mobile tyre fitting in Yate
- Mobile tyre fitting in Barnstaple
- Mobile tyre fitting in Bath
- Mobile tyre fitting in Bideford
- Mobile tyre fitting in Blandford Forum
- Mobile tyre fitting in Bodmin
Why use a mobile fitter?
You do not have to move a vehicle that is not safe to move. No limping to a garage on a space-saver, no waiting room, and no second trip to collect the car.
We bring the same equipment a garage would use, wheel balancing included, to wherever the vehicle already is.
Tyre brands we supply
We stock across three tiers so you can balance cost against tread life and wet-weather performance. If you tell us your budget, we will say honestly which tier makes sense for the mileage you do.
Budget and mid-range
- Farroad
- Hifly
- Churchill
- RoadX
- Infinity
Premium
- Michelin
- Pirelli
- Bridgestone
- Goodyear
- Continental
Need a brand that is not listed? Call us and we will check availability for your size, or search by your tyre size to see what we can fit.







