
We Come To You!
Our mobile tyre fitting service is your convenient solution
Need a tyre in Sevenoaks?
Tell us your tyre size and where you are — we quote before we set off.

Areas We Cover
Drivers across England and Wales — maximum 60 minute response
Popular Tyre Brands Available
We supply & fit new, high-quality and branded tyres for all major vehicles









See what our customers think
Browse through our customers testimonials.
Mobile Tyre Fitting in Sevenoaks
Sevenoaks, Riverhead and M25 junction 5 — 24 hours a day.
Maximum 60 minute response. We have drivers across England and Wales, so a call gets a fitter to the vehicle rather than you moving a car that is not safe to move. Call 07989 606060 with your tyre size and location.
M25 junction 5 is the reason Sevenoaks matters to us. It is the interchange where the M25 meets the A21, and it is one of the more demanding junctions on the southern section — a lot of traffic transferring between two fast roads with short weaving distances.
Add Polhill, the long steep climb on the A21 north of the junction, and you have a stretch of road that puts sustained load on tyres and then asks them to handle a busy interchange. It is where a good share of our Kent motorway work happens.
Roads we get called to around Sevenoaks
- M25 junction 5 and the motorway either side.
- The A21 including Polhill and the Riverhead interchange.
- The A25 east towards Borough Green and west towards Westerham.
- The A224 through Sevenoaks town.
- Sevenoaks station car park and the lanes towards Knole and Seal.
Long climbs and tyre heat
Polhill is a sustained gradient with heavy traffic, and long climbs build heat in a tyre casing. Heat does not create faults, but it finds them. A tyre that has been running underinflated for weeks, or one with existing internal damage from an earlier impact, will often choose a hill like this to fail.
That is the argument for dealing with a slow puncture rather than topping it up. Underinflation is what makes a sidewall flex excessively, and excessive flexing is what generates the heat that eventually breaks the casing down.
Motorway procedure at junction 5
On the M25 itself the sequence matters more than speed. Over the barrier and well back up the embankment. Then ring.
Do not stay in the vehicle and do not stand on the offside looking at the wheel. On a smart motorway stretch with no hard shoulder, if you cannot reach a refuge, keep belts on and call 999 first so the lane can be closed. Our motorway guide sets it all out.
We also cover Tonbridge down the A21 and Dartford round the M25.
What we can do in Sevenoaks
- Mobile tyre fitting — supply and fit a replacement at your home, workplace or the roadside, including balancing and disposal of the old casing.
- Mobile puncture repair — where the damage is inside the repairable area of the tread, a repair is cheaper and quicker than replacement.
- Commercial tyre fitting — vans, minibuses and other light commercial vehicles.
Stuck in Sevenoaks right now? Call 07989 606060 and we will tell you what we can do and what it will cost before we set off.
Before we arrive
- Find your locking wheel nut key. Without it the wheel cannot come off. It is usually in the glovebox, the boot well, or with the spare.
- Read your tyre size off the sidewall, for example 205/55 R16 91V, so we arrive with the right tyre rather than making a second trip.
- If you are on a motorway or dual carriageway, get as far left as you can or into a refuge, then everyone out through the passenger doors, over the barrier and well back from the carriageway — not in the car. Ring with the junction number and your direction of travel.
- Describe where you are, not just your postcode. A junction number, a bay number, a farm, a pub or a bridge puts us on the spot far faster — rural postcodes can cover a mile of near-identical lane. We bring our own lighting, so darkness is not a problem.
More detail in our guides on what to do with a flat tyre on the motorway and checking your tread depth.
Repair or replace
Whether a tyre can be repaired is decided by where the damage is, not by how big the hole looks. Damage inside the central three-quarters of the tread, up to 6mm across, is repairable under BS AU 159. Damage in the shoulder or the sidewall is not, at any size — there is no way to reinforce a sidewall that flexes on every revolution.
The other thing that rules out a repair is having driven on the tyre flat. A short distance is enough: the sidewall folds under the rim and the internal cords break. That often does not deflate the tyre at the time — it shows up days later as a soft rounded bulge, and a tyre in that condition has to be replaced whatever the original puncture looked like.
How the damage was made matters as much as where it is. A nail or a screw pierces, leaving a neat hole that is usually well within the limit. Flint, crushed stone, quarry aggregate and dropped stainless fixings cut instead — a gouge or a tear rather than a puncture — and a cut frequently exceeds the repairable size even when it lands squarely in the middle of the tread. That is why we take the tyre off and look inside before telling you either way, rather than judging it from the outside.
Impact damage behaves the same way. A pothole or a kerb taken at speed compresses the suspension fully and pinches the sidewall between the rim and the obstacle. If that has happened, check both tyres on that side — the rear takes the same hit a fraction of a second after the front — and look for a bulge rather than for a hole.
We carry both outcomes to every job, so a repair that turns out not to be safe does not become a second visit.
Age and wear
Tread depth is not the only thing that retires a tyre. Rubber hardens as it ages whatever the mileage, which is why a caravan, motorhome, trailer or second car can carry almost full tread on a casing that is well past useful life. The four-digit date code on the sidewall gives the week and year it was made — our guide on how long tyres last covers where the line falls.
Depth matters most in standing water. The legal minimum is 1.6mm across the central three-quarters, but a tyre's ability to clear water falls off well above that — by about 3mm you are losing it noticeably, and aquaplaning starts at lower speeds than most drivers expect. Our tread depth guide covers checking it with a 20p coin in about a minute.
Wear patterns are worth reading too. Both outer shoulders going before the middle usually means underinflation, or a lot of cornering and hill descent; one edge alone is more often alignment. We will tell you which it looks like when we are there — see uneven tyre wear for the full picture.
Vans and light commercials
A van needs a tyre carrying the C marking and the correct load index. That is not interchangeable with a passenger tyre of the same nominal size, whatever may have been fitted before — the casing is built to carry more, and a loaded van on passenger-rated tyres is running outside the rating.
Tell us whether the van is loaded when you ring, and we will bring the right fitment first time. Details of what we carry are on the commercial tyres page.
How the repair is done
The wheel comes off, the tyre comes off the rim, and the inside of the casing is inspected before anything else happens. The puncture is then repaired from within using a combined plug and patch, and the wheel is balanced before it goes back on.
That inspection is the part that matters. An external plug pushed into the tread without removing the tyre is a get-you-home measure: it can seal the hole while leaving damage inside the casing entirely undetected, and that damage is what causes tyres to fail later at speed. It is the same job a garage does, done where the vehicle already is.
A slow leak with no puncture to find
A tyre that loses air over days with nothing in the tread has usually failed at the seal rather than the surface — a corroded alloy bead seat, or a perished valve stem. Neither can be found with the tyre still on the rim, and neither is fixed by topping the pressure up.
It typically announces itself on the first cold morning of the year. Cold air contracts, dropping the pressure a few PSI, and a leak that was tolerable through mild weather is a visibly flat tyre by the time you come out to the car. The fix is the tyre off the rim, the sealing face cleaned back to sound metal, and a new valve.
Working conditions around Sevenoaks
Gradients. A sustained climb builds heat in the casing, and heat finds whatever weakness is already there — which is why underinflated or previously damaged tyres are the ones that let go on a long pull rather than on the flat. On a steep slope we will ask to move onto level ground before jacking: a handbrake holds two wheels, and that margin drops sharply the moment one of them comes off the ground.
Station and workplace car parks. A commuter car park is where slow punctures hide. Eleven hours standing with a short drive at each end means you never drive far enough or fast enough to feel a tyre going down — so it presents as a flat at six in the evening rather than as a soft one in the morning. These are also the easiest jobs we do: the car is stationary for hours, the surface is flat, and there is room to work. Leave us the bay number and where the locking wheel nut key lives and it is finished before you are back, which beats finding it flat at the end of the day.
Common questions in Sevenoaks
- Is topping up a slow puncture every week doing harm?
- Yes. Running underinflated flexes the sidewall and builds heat, which damages the casing from the inside — and it can take a puncture that was repairable past the point of repair.
- I am stuck in a live lane on the M25 with no refuge in reach.
- Dial 999 before you ring us. Only they can close the lane, and nothing else should happen until that is done.
- Can you fit at Sevenoaks station during the day?
- Yes, and it is one of our regular jobs here given the London commute. Tell us which of the car parks — they are on both sides of the line and not connected.
- Do you cover the Polhill and Dunton Green side as well as the town?
- Yes, and the A21 and M25 junction 5 with it. If you are on any of those, lead with the road and direction; postcodes there are too coarse to help.
- Do you cover Riverhead, Seal and Borough Green?
- Yes, across TN13 to TN15.
Not in Sevenoaks?
We cover the rest of Kent and beyond. If you are closer to one of these, the same service and the same number applies:
- Mobile tyre fitting in Ashford
- Mobile tyre fitting in Broadstairs
- Mobile tyre fitting in Canterbury
- Mobile tyre fitting in Chatham
- Mobile tyre fitting in Dartford
- Mobile tyre fitting in Deal
- Mobile tyre fitting in Dover
- Mobile tyre fitting in Faversham
- Mobile tyre fitting in Folkestone
- Mobile tyre fitting in Gillingham
- Mobile tyre fitting in Gravesend
- Mobile tyre fitting in Herne Bay
Why use a mobile fitter?
You do not have to move a vehicle that is not safe to move. No limping to a garage on a space-saver, no waiting room, and no second trip to collect the car.
We bring the same equipment a garage would use, wheel balancing included, to wherever the vehicle already is.
Tyre brands we supply
We stock across three tiers so you can balance cost against tread life and wet-weather performance. If you tell us your budget, we will say honestly which tier makes sense for the mileage you do.
Budget and mid-range
- Farroad
- Hifly
- Churchill
- RoadX
- Infinity
Premium
- Michelin
- Pirelli
- Bridgestone
- Goodyear
- Continental
Need a brand that is not listed? Call us and we will check availability for your size, or search by your tyre size to see what we can fit.







