
We Come To You!
Our mobile tyre fitting service is your convenient solution
Need a tyre in Aylesford?
Tell us your tyre size and where you are — we quote before we set off.

Areas We Cover
Drivers across England and Wales — maximum 60 minute response
Popular Tyre Brands Available
We supply & fit new, high-quality and branded tyres for all major vehicles









See what our customers think
Browse through our customers testimonials.
Mobile Tyre Fitting in Aylesford
Aylesford, Station Road and junction 5 — 24 hours a day.
Maximum 60 minute response. We have drivers across England and Wales, so a call gets a fitter to the vehicle rather than you moving a car that is not safe to move. Call 07989 606060 with your tyre size and location.
Aylesford village is a thin strip of buildings squeezed between the Medway and the railway, and both of them limit what can be done there. The medieval ragstone bridge in the middle of it has carried no motor traffic since 1997, when a new road bridge opened a little upstream linking Forstal Road to Station Road. The old one now takes pedestrians, cyclists and horses only.
Station Road crosses the railway on a public level crossing with full barriers, worked by a signaller, and it is the direct link between the village and the A20. Above all of it the M20 runs east to west, and the junction here is junction 5 — signed Aylesford, and frequently confused with junction 6 further on.
Roads we get called to around Aylesford
- M20 junction 5 and the interchange onto the A20.
- The A20 — London Road and Coldharbour Lane.
- Station Road and the level crossing beside the station.
- Forstal Road and the 1997 river bridge.
- The village High Street and the approach to the old bridge.
- Mills Road and the Quarry Wood estate, and Bellingham Way on the old mill ground.
A bridge you cannot drive over
The old bridge is fourteenth-century, built of Kentish ragstone, and for the best part of seven hundred years it was the only way across the river here. Traffic came off it when the replacement opened, and the village is the better for it — but the practical consequence is that the two banks are joined for vehicles only by the newer crossing.
So a car that is a hundred yards away across the water is a drive round rather than a walk over, and directions that treat the old bridge as a road send you to a point where you cannot continue. If you are on the far bank, say so plainly and name Forstal Road or Station Road, and we will approach from the right side the first time.
The crossing on Station Road
The barriers sit between the village and the A20 side of the railway, and when they are down the queue on Station Road builds quickly because there is no parallel route for it to spill into. The same closure holds traffic at Snodland up the valley, so a busy period on the line is felt in both places at once.
If a tyre goes while you are sitting in that queue, getting clear of it is worth more than where you end up — the cars behind cannot go round you and the road is not wide enough to pass. The side turnings on either approach are better ground for us than the queue is.
Quarry Wood, the A20 and the old mill site
South of the village, Quarry Wood on Mills Road is a large estate of industrial and logistics units a mile from junction 5, with trade units and motor dealerships strung along the A20 on both sides of it. North of the village, the newsprint mill that closed in 2015 has been demolished and the ground rebuilt as a logistics park, with a new link road put through it to spread traffic between the junctions.
That gives ME20 an unusual amount of working-vehicle traffic for a place with a medieval village at the middle of it. Give us the unit and the estate, and say whether there is a gatehouse or a barrier we need to be expected at.
We also cover Larkfield along the A20, Snodland up the Medway valley and Maidstone to the south-east.
What we can do in Aylesford
- Mobile tyre fitting — supply and fit a replacement at your home, workplace or the roadside, including balancing and disposal of the old casing.
- Mobile puncture repair — where the damage is inside the repairable area of the tread, a repair is cheaper and quicker than replacement.
- Commercial tyre fitting — vans, minibuses and other light commercial vehicles.
Stuck in Aylesford right now? Call 07989 606060 and we will tell you what we can do and what it will cost before we set off.
Before we arrive
- Find your locking wheel nut key. Without it the wheel cannot come off. It is usually in the glovebox, the boot well, or with the spare.
- Read your tyre size off the sidewall, for example 205/55 R16 91V, so we arrive with the right tyre rather than making a second trip.
- If you are on a motorway or dual carriageway, get as far left as you can or into a refuge, then everyone out through the passenger doors, over the barrier and well back from the carriageway — not in the car. Ring with the junction number and your direction of travel.
- Describe where you are, not just your postcode. A junction number, a bay number, a farm, a pub or a bridge puts us on the spot far faster — rural postcodes can cover a mile of near-identical lane. We bring our own lighting, so darkness is not a problem.
More detail in our guides on what to do with a flat tyre on the motorway and checking your tread depth.
Repair or replace
Whether a tyre can be repaired is decided by where the damage is, not by how big the hole looks. Damage inside the central three-quarters of the tread, up to 6mm across, is repairable under BS AU 159. Damage in the shoulder or the sidewall is not, at any size — there is no way to reinforce a sidewall that flexes on every revolution.
The other thing that rules out a repair is having driven on the tyre flat. A short distance is enough: the sidewall folds under the rim and the internal cords break. That often does not deflate the tyre at the time — it shows up days later as a soft rounded bulge, and a tyre in that condition has to be replaced whatever the original puncture looked like.
How the damage was made matters as much as where it is. A nail or a screw pierces, leaving a neat hole that is usually well within the limit. Flint, crushed stone, quarry aggregate and dropped stainless fixings cut instead — a gouge or a tear rather than a puncture — and a cut frequently exceeds the repairable size even when it lands squarely in the middle of the tread. That is why we take the tyre off and look inside before telling you either way, rather than judging it from the outside.
Impact damage behaves the same way. A pothole or a kerb taken at speed compresses the suspension fully and pinches the sidewall between the rim and the obstacle. If that has happened, check both tyres on that side — the rear takes the same hit a fraction of a second after the front — and look for a bulge rather than for a hole.
We carry both outcomes to every job, so a repair that turns out not to be safe does not become a second visit.
Age and wear
Tread depth is not the only thing that retires a tyre. Rubber hardens as it ages whatever the mileage, which is why a caravan, motorhome, trailer or second car can carry almost full tread on a casing that is well past useful life. The four-digit date code on the sidewall gives the week and year it was made — our guide on how long tyres last covers where the line falls.
Depth matters most in standing water. The legal minimum is 1.6mm across the central three-quarters, but a tyre's ability to clear water falls off well above that — by about 3mm you are losing it noticeably, and aquaplaning starts at lower speeds than most drivers expect. Our tread depth guide covers checking it with a 20p coin in about a minute.
Wear patterns are worth reading too. Both outer shoulders going before the middle usually means underinflation, or a lot of cornering and hill descent; one edge alone is more often alignment. We will tell you which it looks like when we are there — see uneven tyre wear for the full picture.
Vans and light commercials
A van needs a tyre carrying the C marking and the correct load index. That is not interchangeable with a passenger tyre of the same nominal size, whatever may have been fitted before — the casing is built to carry more, and a loaded van on passenger-rated tyres is running outside the rating.
Tell us whether the van is loaded when you ring, and we will bring the right fitment first time. Details of what we carry are on the commercial tyres page.
How the repair is done
The wheel comes off, the tyre comes off the rim, and the inside of the casing is inspected before anything else happens. The puncture is then repaired from within using a combined plug and patch, and the wheel is balanced before it goes back on.
That inspection is the part that matters. An external plug pushed into the tread without removing the tyre is a get-you-home measure: it can seal the hole while leaving damage inside the casing entirely undetected, and that damage is what causes tyres to fail later at speed. It is the same job a garage does, done where the vehicle already is.
A slow leak with no puncture to find
A tyre that loses air over days with nothing in the tread has usually failed at the seal rather than the surface — a corroded alloy bead seat, or a perished valve stem. Neither can be found with the tyre still on the rim, and neither is fixed by topping the pressure up.
It typically announces itself on the first cold morning of the year. Cold air contracts, dropping the pressure a few PSI, and a leak that was tolerable through mild weather is a visibly flat tyre by the time you come out to the car. The fix is the tyre off the rim, the sealing face cleaned back to sound metal, and a new valve.
Working conditions around Aylesford
Level crossings. A vehicle stopped on a crossing is an emergency, not a breakdown. Get everybody out and well clear on the far side from the barriers, then use the railway telephone at the crossing, or ring 999 and ask for the railway, before you ring anybody else. Only the signaller can stop a train, and that has to happen before anything else does.
Trade and industrial estates. Yard surfaces collect banding, pallet nails and dropped fixings, and that sort of debris cuts and gouges rather than piercing cleanly — damage that frequently falls outside the repairable size limit even when it lands in the middle of the tread. We keep commercial fitments on the van for the vehicles these estates run.
Common questions in Aylesford
- Can I get to the village over the old bridge?
- Not in a vehicle. It has been pedestrians, cycles and horses only since the replacement bridge opened in 1997. Use Forstal Road or Station Road instead.
- Is Aylesford junction 5 or junction 6?
- Junction 5 — it is signed Aylesford. Junction 6 is Sandling and takes you somewhere else entirely, so the number is worth getting right before you set off or before we do.
- The barriers on Station Road have been down for ages.
- That happens here. It is a manually worked crossing and the queue has nowhere else to go, so it backs up fast. Tell us which side of the line you are on and we will come the way that is open.
- Can you attend Quarry Wood and the units off the A20?
- Yes, cars and light commercials alike. Give us the unit and the estate name, and mention any gatehouse or barrier so we are expected rather than waiting at it.
- Do you cover Eccles, Ditton, Pratling Street and Forstal?
- Yes, across ME20 and both sides of the M20 around junction 5.
Not in Aylesford?
We cover the rest of Kent and beyond. If you are closer to one of these, the same service and the same number applies:
- Mobile tyre fitting in Ashford
- Mobile tyre fitting in Birchington
- Mobile tyre fitting in Borough Green
- Mobile tyre fitting in Broadstairs
- Mobile tyre fitting in Canterbury
- Mobile tyre fitting in Charing
- Mobile tyre fitting in Chatham
- Mobile tyre fitting in Cranbrook
- Mobile tyre fitting in Dartford
- Mobile tyre fitting in Deal
- Mobile tyre fitting in Dover
- Mobile tyre fitting in Dymchurch
Why use a mobile fitter?
You do not have to move a vehicle that is not safe to move. No limping to a garage on a space-saver, no waiting room, and no second trip to collect the car.
We bring the same equipment a garage would use, wheel balancing included, to wherever the vehicle already is.
Tyre brands we supply
We stock across three tiers so you can balance cost against tread life and wet-weather performance. If you tell us your budget, we will say honestly which tier makes sense for the mileage you do.
Budget and mid-range
- Farroad
- Hifly
- Churchill
- RoadX
- Infinity
Premium
- Michelin
- Pirelli
- Bridgestone
- Goodyear
- Continental
Need a brand that is not listed? Call us and we will check availability for your size, or see how mobile tyre fitting works.







