
We Come To You!
Our mobile tyre fitting service is your convenient solution
Need a tyre in Helston?
Tell us your tyre size and where you are — we quote before we set off.

Areas We Cover
Drivers across England and Wales — maximum 60 minute response
Popular Tyre Brands Available
We supply & fit new, high-quality and branded tyres for all major vehicles









See what our customers think
Browse through our customers testimonials.
Mobile Tyre Fitting in Helston
Helston, Culdrose and the Lizard — 24 hours a day.
Maximum 60 minute response. We have drivers across England and Wales, so a call gets a fitter to the vehicle rather than you moving a car that is not safe to move. Call 07989 606060 with your tyre size and location.
Helston is the gateway to the Lizard peninsula, the most southerly point in Britain, with the naval air station at Culdrose on its doorstep. The A394 and A3083 are the roads that matter and everything beyond them is lanes.
Roads and places we get called to around Helston
- The A394 — west towards Penzance, east towards Falmouth and Truro.
- The A3083 south to Culdrose, Mullion and the Lizard.
- The Lizard lanes towards Coverack, Cadgwith and Kynance.
- Helston town centre, Coinagehall Street and the steep hill through it.
- Porthleven, the harbour and the coast road.
Down the Lizard
The A3083 runs the length of the peninsula and it is the only road of any size on it. Off it, everything is single-track lane with high Cornish hedges — stone-cored banks rather than hedgerows, which means no give at all if you clip one.
Those banks are also why describing a position is hard: they block the view of everything except the road ahead. A farm, a chapel, a village name or a junction is what gets us there, and out towards Coverack and Cadgwith the villages are the only reliable markers.
Signal is unreliable across much of the peninsula. If you are heading down with a tyre you are unsure about, deal with it in Helston.
Cornish hedge damage
Clipping a Cornish hedge is not like clipping a verge. There is stone under the turf, and a wheel that touches one at any speed tends to take a sidewall cut or a rim knock rather than a scuff.
If you have caught one, look at the sidewall and check whether the steering has picked up a vibration. Those are two different problems and both are common here.
Helston hill and Porthleven
Coinagehall Street runs steeply down through the town, and the streets off it are narrow with on-street parking. Porthleven's harbour is tighter again, and in a south-westerly gale the sea comes over the harbour wall onto the road.
We also cover Falmouth along the A394 and Penzance to the west.
What we can do in Helston
- Mobile tyre fitting — supply and fit a replacement at your home, workplace or the roadside, including balancing and disposal of the old casing.
- Mobile puncture repair — where the damage is inside the repairable area of the tread, a repair is cheaper and quicker than replacement.
- Commercial tyre fitting — vans, minibuses and other light commercial vehicles.
Stuck in Helston right now? Call 07989 606060 and we will tell you what we can do and what it will cost before we set off.
Before we arrive
- Find your locking wheel nut key. Without it the wheel cannot come off. It is usually in the glovebox, the boot well, or with the spare.
- Read your tyre size off the sidewall, for example 205/55 R16 91V, so we arrive with the right tyre rather than making a second trip.
- If you are on a motorway or dual carriageway, get as far left as you can or into a refuge, then everyone out through the passenger doors, over the barrier and well back from the carriageway — not in the car. Ring with the junction number and your direction of travel.
- Describe where you are, not just your postcode. A junction number, a bay number, a farm, a pub or a bridge puts us on the spot far faster — rural postcodes can cover a mile of near-identical lane. We bring our own lighting, so darkness is not a problem.
More detail in our guides on what to do with a flat tyre on the motorway and checking your tread depth.
Repair or replace
Whether a tyre can be repaired is decided by where the damage is, not by how big the hole looks. Damage inside the central three-quarters of the tread, up to 6mm across, is repairable under BS AU 159. Damage in the shoulder or the sidewall is not, at any size — there is no way to reinforce a sidewall that flexes on every revolution.
The other thing that rules out a repair is having driven on the tyre flat. A short distance is enough: the sidewall folds under the rim and the internal cords break. That often does not deflate the tyre at the time — it shows up days later as a soft rounded bulge, and a tyre in that condition has to be replaced whatever the original puncture looked like.
How the damage was made matters as much as where it is. A nail or a screw pierces, leaving a neat hole that is usually well within the limit. Flint, crushed stone, quarry aggregate and dropped stainless fixings cut instead — a gouge or a tear rather than a puncture — and a cut frequently exceeds the repairable size even when it lands squarely in the middle of the tread. That is why we take the tyre off and look inside before telling you either way, rather than judging it from the outside.
Impact damage behaves the same way. A pothole or a kerb taken at speed compresses the suspension fully and pinches the sidewall between the rim and the obstacle. If that has happened, check both tyres on that side — the rear takes the same hit a fraction of a second after the front — and look for a bulge rather than for a hole.
We carry both outcomes to every job, so a repair that turns out not to be safe does not become a second visit.
Age and wear
Tread depth is not the only thing that retires a tyre. Rubber hardens as it ages whatever the mileage, which is why a caravan, motorhome, trailer or second car can carry almost full tread on a casing that is well past useful life. The four-digit date code on the sidewall gives the week and year it was made — our guide on how long tyres last covers where the line falls.
Depth matters most in standing water. The legal minimum is 1.6mm across the central three-quarters, but a tyre's ability to clear water falls off well above that — by about 3mm you are losing it noticeably, and aquaplaning starts at lower speeds than most drivers expect. Our tread depth guide covers checking it with a 20p coin in about a minute.
Wear patterns are worth reading too. Both outer shoulders going before the middle usually means underinflation, or a lot of cornering and hill descent; one edge alone is more often alignment. We will tell you which it looks like when we are there — see uneven tyre wear for the full picture.
Vans and light commercials
A van needs a tyre carrying the C marking and the correct load index. That is not interchangeable with a passenger tyre of the same nominal size, whatever may have been fitted before — the casing is built to carry more, and a loaded van on passenger-rated tyres is running outside the rating.
Tell us whether the van is loaded when you ring, and we will bring the right fitment first time. Details of what we carry are on the commercial tyres page.
How the repair is done
The wheel comes off, the tyre comes off the rim, and the inside of the casing is inspected before anything else happens. The puncture is then repaired from within using a combined plug and patch, and the wheel is balanced before it goes back on.
That inspection is the part that matters. An external plug pushed into the tread without removing the tyre is a get-you-home measure: it can seal the hole while leaving damage inside the casing entirely undetected, and that damage is what causes tyres to fail later at speed. It is the same job a garage does, done where the vehicle already is.
A slow leak with no puncture to find
A tyre that loses air over days with nothing in the tread has usually failed at the seal rather than the surface — a corroded alloy bead seat, or a perished valve stem. Neither can be found with the tyre still on the rim, and neither is fixed by topping the pressure up.
It typically announces itself on the first cold morning of the year. Cold air contracts, dropping the pressure a few PSI, and a leak that was tolerable through mild weather is a visibly flat tyre by the time you come out to the car. The fix is the tyre off the rim, the sealing face cleaned back to sound metal, and a new valve.
Working conditions around Helston
Salt. Sea air corrodes far harder than road salt does, and it works on the parts of a wheel you cannot see. Pitted alloy bead seats and corroded valve stems are the standard coastal fault, and they present as a slow leak with no puncture anywhere in the tread. Vehicles parked near the front year round get it worst.
Gradients. A sustained climb builds heat in the casing, and heat finds whatever weakness is already there — which is why underinflated or previously damaged tyres are the ones that let go on a long pull rather than on the flat. On a steep slope we will ask to move onto level ground before jacking: a handbrake holds two wheels, and that margin drops sharply the moment one of them comes off the ground.
Lanes and farm access. Single-track lanes need somewhere to put both your vehicle and ours without blocking the road, so a gateway or a passing place is worth reaching if the car is still drivable. Agricultural traffic drops wire, staples and broken tines, and harvest spreads them well beyond the field gate — which is why the lanes produce punctures out of proportion to how little traffic they carry.
Common questions in Helston
- What is different about a Cornish hedge?
- There is stone under the turf. Clipping one gives a sidewall cut or a knocked rim rather than a scuff, so check both after any contact.
- What locates me best down the Lizard?
- A farm, a chapel, a village or a junction. The hedges block the view of everything but the road, so villages are the only reliable markers.
- Should I head down the peninsula with a soft tyre?
- Deal with it in Helston. Signal is unreliable down there and the lanes are single track with nowhere useful to stop.
- The sea is coming over the wall at Porthleven.
- Then we will not be working on the harbour road. Tell us and we will arrange somewhere back from the front instead.
- Do you cover Mullion, Porthleven and St Keverne?
- Yes, across TR12 and TR13.
Not in Helston?
We cover the rest of Cornwall and beyond. If you are closer to one of these, the same service and the same number applies:
- Mobile tyre fitting in Bodmin
- Mobile tyre fitting in Bude
- Mobile tyre fitting in Camborne
- Mobile tyre fitting in Falmouth
- Mobile tyre fitting in Launceston
- Mobile tyre fitting in Newquay
- Mobile tyre fitting in Penzance
- Mobile tyre fitting in Redruth
- Mobile tyre fitting in Saltash
- Mobile tyre fitting in St Austell
- Mobile tyre fitting in Truro
- Mobile tyre fitting in Barnstaple
Why use a mobile fitter?
You do not have to move a vehicle that is not safe to move. No limping to a garage on a space-saver, no waiting room, and no second trip to collect the car.
We bring the same equipment a garage would use, wheel balancing included, to wherever the vehicle already is.
Tyre brands we supply
We stock across three tiers so you can balance cost against tread life and wet-weather performance. If you tell us your budget, we will say honestly which tier makes sense for the mileage you do.
Budget and mid-range
- Farroad
- Hifly
- Churchill
- RoadX
- Infinity
Premium
- Michelin
- Pirelli
- Bridgestone
- Goodyear
- Continental
Need a brand that is not listed? Call us and we will check availability for your size, or search by your tyre size to see what we can fit.







