
We Come To You!
Our mobile tyre fitting service is your convenient solution
Need a tyre in Camelford?
Tell us your tyre size and where you are — we quote before we set off.

Areas We Cover
Drivers across England and Wales — maximum 60 minute response
Popular Tyre Brands Available
We supply & fit new, high-quality and branded tyres for all major vehicles









See what our customers think
Browse through our customers testimonials.
Mobile Tyre Fitting in Camelford
Camelford, and the A39 that goes straight through it.
Maximum 60 minute response. We have drivers across England and Wales, so a call gets a fitter to the vehicle rather than you moving a car that is not safe to move. Call 07989 606060 with your tyre size and location.
The A39 does not go round Camelford; it goes through it, and the town's main street is the A39. That single fact accounts for most of what we get called to here. The carriageway through the middle is narrow enough to hold the traffic up, the town is designated an air quality management area because of what sits in it, and the proportion of that traffic which is lorries and agricultural vehicles is high.
A bypass has been drawn, argued over and costed for decades. The most recent scheme was taken as far as a route north of the town crossing the Camel valley on a viaduct before the Department for Transport confirmed in June 2025 that it would not fund it, and the project was closed down. For the foreseeable future the main street stays the main road.
Roads we get called to around Camelford
- The A39 through the town, north to Collan's Cross and south towards Wadebridge.
- The B3266 south towards Bodmin and the moor edge.
- The B3314 where it joins the A39 north of the town.
- The side streets and car parking off the main street.
- The road east towards Roughtor and the moorland edge.
- The laybys on the A39 either side of the town.
Stopping on a main street that is also a trunk road
A puncture in the middle of Camelford leaves you in a position that a wider town would not create. The main street carries through traffic that has come off open A-road at speed and then slowed, in both directions, with parked cars along it and no meaningful refuge. There is nowhere on that stretch that is genuinely out of the way.
If the car will move, the answer is almost always to get it into one of the car parks off the main street before we arrive. That takes the job off the A39 entirely, and it means we are not adding a van to a street already too narrow for what is on it.
North and south of the town
Either side of Camelford the A39 opens out and behaves like the trunk route it is, with laybys off the running carriageway and no deceleration lane to speak of. The B3266 heading south towards Bodmin is a different animal again: a proper Cornish B road along the western edge of the moor, and the place where the agricultural traffic that comes through the town has actually come from.
Between the two, the practical advice is the same one we give on every job here — decide before you set off whether the tyre will get you to the town, because sorting it out at a layby three miles out is a great deal simpler than doing it in the middle of the main street.
Bodmin is south on the B3266, Launceston is east across the moor, and Delabole and Tintagel are to the west.
What we can do in Camelford
- Mobile tyre fitting — supply and fit a replacement at your home, workplace or the roadside, including balancing and disposal of the old casing.
- Mobile puncture repair — where the damage is inside the repairable area of the tread, a repair is cheaper and quicker than replacement.
- Commercial tyre fitting — vans, minibuses and other light commercial vehicles.
Stuck in Camelford right now? Call 07989 606060 and we will tell you what we can do and what it will cost before we set off.
Before we arrive
- Find your locking wheel nut key. Without it the wheel cannot come off. It is usually in the glovebox, the boot well, or with the spare.
- Read your tyre size off the sidewall, for example 205/55 R16 91V, so we arrive with the right tyre rather than making a second trip.
- If you are on a motorway or dual carriageway, get as far left as you can or into a refuge, then everyone out through the passenger doors, over the barrier and well back from the carriageway — not in the car. Ring with the junction number and your direction of travel.
- Describe where you are, not just your postcode. A junction number, a bay number, a farm, a pub or a bridge puts us on the spot far faster — rural postcodes can cover a mile of near-identical lane. We bring our own lighting, so darkness is not a problem.
More detail in our guides on what to do with a flat tyre on the motorway and checking your tread depth.
Repair or replace
Whether a tyre can be repaired is decided by where the damage is, not by how big the hole looks. Damage inside the central three-quarters of the tread, up to 6mm across, is repairable under BS AU 159. Damage in the shoulder or the sidewall is not, at any size — there is no way to reinforce a sidewall that flexes on every revolution.
The other thing that rules out a repair is having driven on the tyre flat. A short distance is enough: the sidewall folds under the rim and the internal cords break. That often does not deflate the tyre at the time — it shows up days later as a soft rounded bulge, and a tyre in that condition has to be replaced whatever the original puncture looked like.
How the damage was made matters as much as where it is. A nail or a screw pierces, leaving a neat hole that is usually well within the limit. Flint, crushed stone, quarry aggregate and dropped stainless fixings cut instead — a gouge or a tear rather than a puncture — and a cut frequently exceeds the repairable size even when it lands squarely in the middle of the tread. That is why we take the tyre off and look inside before telling you either way, rather than judging it from the outside.
Impact damage behaves the same way. A pothole or a kerb taken at speed compresses the suspension fully and pinches the sidewall between the rim and the obstacle. If that has happened, check both tyres on that side — the rear takes the same hit a fraction of a second after the front — and look for a bulge rather than for a hole.
We carry both outcomes to every job, so a repair that turns out not to be safe does not become a second visit.
Age and wear
Tread depth is not the only thing that retires a tyre. Rubber hardens as it ages whatever the mileage, which is why a caravan, motorhome, trailer or second car can carry almost full tread on a casing that is well past useful life. The four-digit date code on the sidewall gives the week and year it was made — our guide on how long tyres last covers where the line falls.
Depth matters most in standing water. The legal minimum is 1.6mm across the central three-quarters, but a tyre's ability to clear water falls off well above that — by about 3mm you are losing it noticeably, and aquaplaning starts at lower speeds than most drivers expect. Our tread depth guide covers checking it with a 20p coin in about a minute.
Wear patterns are worth reading too. Both outer shoulders going before the middle usually means underinflation, or a lot of cornering and hill descent; one edge alone is more often alignment. We will tell you which it looks like when we are there — see uneven tyre wear for the full picture.
Vans and light commercials
A van needs a tyre carrying the C marking and the correct load index. That is not interchangeable with a passenger tyre of the same nominal size, whatever may have been fitted before — the casing is built to carry more, and a loaded van on passenger-rated tyres is running outside the rating.
Tell us whether the van is loaded when you ring, and we will bring the right fitment first time. Details of what we carry are on the commercial tyres page.
How the repair is done
The wheel comes off, the tyre comes off the rim, and the inside of the casing is inspected before anything else happens. The puncture is then repaired from within using a combined plug and patch, and the wheel is balanced before it goes back on.
That inspection is the part that matters. An external plug pushed into the tread without removing the tyre is a get-you-home measure: it can seal the hole while leaving damage inside the casing entirely undetected, and that damage is what causes tyres to fail later at speed. It is the same job a garage does, done where the vehicle already is.
A slow leak with no puncture to find
A tyre that loses air over days with nothing in the tread has usually failed at the seal rather than the surface — a corroded alloy bead seat, or a perished valve stem. Neither can be found with the tyre still on the rim, and neither is fixed by topping the pressure up.
It typically announces itself on the first cold morning of the year. Cold air contracts, dropping the pressure a few PSI, and a leak that was tolerable through mild weather is a visibly flat tyre by the time you come out to the car. The fix is the tyre off the rim, the sealing face cleaned back to sound metal, and a new valve.
Working conditions around Camelford
Old-style laybys. On the pre-motorway trunk roads the laybys open straight off the running carriageway with no deceleration or acceleration lane. If you have to stop, one is still far better than the verge — but rejoining is the genuinely dangerous part, because you are accelerating from a standstill into seventy-mile-an-hour traffic. Wait for a real gap rather than a hopeful one; that applies to our vans as much as to you, which is why we quote realistic times on these roads rather than optimistic ones.
Those laybys are also heavily used for overnight lorry parking, and they collect what comes with it: banding, strapping, broken fixings and fragments of retread carrying embedded steel belt wire. Wire of that sort tears a ragged line rather than leaving a neat hole, and it can open a separation between the belts internally while showing very little on the surface — so it gets inspected from inside the tyre before anyone decides it is repairable. Their edges are usually crushed where heavy vehicles have stood on them, so mention it if the ground is broken and the base plates come too.
Common questions in Camelford
- Is there anywhere to stop safely on the main street?
- Not really. That is the honest answer and it is why we ask whether the car can reach a car park first. Fifty yards of movement here is worth more than anywhere else on the A39.
- Is the bypass happening?
- No. Funding was refused in June 2025 and the scheme was closed down, so the A39 continues through the town for the time being.
- I am in a layby on the A39 outside the town.
- Tell us which side of Camelford you are on and which direction you were travelling. The laybys either side look alike and getting that wrong adds several miles to the approach.
- Do you cover the moor edge and Roughtor?
- Yes, across PL32 and out onto the western side of the moor, though a gate, a cattle grid or a farm entrance places you far better than an address does out there.
Not in Camelford?
We cover the rest of Cornwall and beyond. If you are closer to one of these, the same service and the same number applies:
- Mobile tyre fitting in Bodmin
- Mobile tyre fitting in Bude
- Mobile tyre fitting in Bugle
- Mobile tyre fitting in Callington
- Mobile tyre fitting in Camborne
- Mobile tyre fitting in Chacewater
- Mobile tyre fitting in Delabole
- Mobile tyre fitting in Devoran
- Mobile tyre fitting in Falmouth
- Mobile tyre fitting in Fowey
- Mobile tyre fitting in Grampound
- Mobile tyre fitting in Hayle
Why use a mobile fitter?
You do not have to move a vehicle that is not safe to move. No limping to a garage on a space-saver, no waiting room, and no second trip to collect the car.
We bring the same equipment a garage would use, wheel balancing included, to wherever the vehicle already is.
Tyre brands we supply
We stock across three tiers so you can balance cost against tread life and wet-weather performance. If you tell us your budget, we will say honestly which tier makes sense for the mileage you do.
Budget and mid-range
- Farroad
- Hifly
- Churchill
- RoadX
- Infinity
Premium
- Michelin
- Pirelli
- Bridgestone
- Goodyear
- Continental
Need a brand that is not listed? Call us and we will check availability for your size, or see how mobile tyre fitting works.







