
We Come To You!
Our mobile tyre fitting service is your convenient solution
Need a tyre in Haslemere?
Tell us your tyre size and where you are — we quote before we set off.

Areas We Cover
Drivers across England and Wales — maximum 60 minute response
Popular Tyre Brands Available
We supply & fit new, high-quality and branded tyres for all major vehicles









See what our customers think
Browse through our customers testimonials.
Mobile Tyre Fitting in Haslemere
Haslemere, Hindhead and the greensand hills — 24 hours a day.
Maximum 60 minute response. We have drivers across England and Wales, so a call gets a fitter to the vehicle rather than you moving a car that is not safe to move. Call 07989 606060 with your tyre size and location.
Haslemere sits high in the greensand hills where Surrey, Sussex and Hampshire meet — the highest town in Surrey, and it feels it. The A286 and A287 serve it and the A3 passes north through the Hindhead tunnel.
Roads and places we get called to around Haslemere
- The A3 and the Hindhead tunnel a few miles north.
- The A286 — south towards Midhurst and Chichester, north towards Milford.
- The A287 west towards Hindhead and Farnham.
- The Devil's Punch Bowl and the National Trust car parks.
- The station, the High Street and the wooded lanes around Blackdown.
The Hindhead tunnel
The A3 runs under the Devil's Punch Bowl in a twin-bore tunnel over a mile long. There is nowhere to stop inside it and it is monitored throughout — if a tyre goes in there, keep going and stop beyond the portal if the vehicle will move at all.
If it will not, use the emergency phones rather than ringing us first. The control room can close a bore, which we cannot, and nothing else should happen until that is done.
The old A3 over the Punch Bowl is closed to through traffic now, so there is no alternative surface route — which is exactly why sorting a soft tyre before you commit matters here.
Height and weather
Haslemere is high enough that it gets weather the Surrey lowlands do not. Fog sits on the greensand ridge, and ice forms on the hill roads when the valleys are clear. Tell us what it is doing where you actually are rather than what the forecast says for Surrey.
The lanes
The lanes around Blackdown and out towards Fernhurst and Northchapel are steep, narrow and heavily wooded, several of them sunken between sandy banks. Greensand is exactly what it sounds like under a jack — it looks solid and gives way.
Give us the lane by name and a farm or a house if you can. Under that tree cover a postcode places you within a large wood and not much more.
We also cover Godalming up the A286 and Farnham along the A287.
What we can do in Haslemere
- Mobile tyre fitting — supply and fit a replacement at your home, workplace or the roadside, including balancing and disposal of the old casing.
- Mobile puncture repair — where the damage is inside the repairable area of the tread, a repair is cheaper and quicker than replacement.
- Commercial tyre fitting — vans, minibuses and other light commercial vehicles.
Stuck in Haslemere right now? Call 07989 606060 and we will tell you what we can do and what it will cost before we set off.
Before we arrive
- Find your locking wheel nut key. Without it the wheel cannot come off. It is usually in the glovebox, the boot well, or with the spare.
- Read your tyre size off the sidewall, for example 205/55 R16 91V, so we arrive with the right tyre rather than making a second trip.
- If you are on a motorway or dual carriageway, get as far left as you can or into a refuge, then everyone out through the passenger doors, over the barrier and well back from the carriageway — not in the car. Ring with the junction number and your direction of travel.
- Describe where you are, not just your postcode. A junction number, a bay number, a farm, a pub or a bridge puts us on the spot far faster — rural postcodes can cover a mile of near-identical lane. We bring our own lighting, so darkness is not a problem.
More detail in our guides on what to do with a flat tyre on the motorway and checking your tread depth.
Repair or replace
Whether a tyre can be repaired is decided by where the damage is, not by how big the hole looks. Damage inside the central three-quarters of the tread, up to 6mm across, is repairable under BS AU 159. Damage in the shoulder or the sidewall is not, at any size — there is no way to reinforce a sidewall that flexes on every revolution.
The other thing that rules out a repair is having driven on the tyre flat. A short distance is enough: the sidewall folds under the rim and the internal cords break. That often does not deflate the tyre at the time — it shows up days later as a soft rounded bulge, and a tyre in that condition has to be replaced whatever the original puncture looked like.
How the damage was made matters as much as where it is. A nail or a screw pierces, leaving a neat hole that is usually well within the limit. Flint, crushed stone, quarry aggregate and dropped stainless fixings cut instead — a gouge or a tear rather than a puncture — and a cut frequently exceeds the repairable size even when it lands squarely in the middle of the tread. That is why we take the tyre off and look inside before telling you either way, rather than judging it from the outside.
Impact damage behaves the same way. A pothole or a kerb taken at speed compresses the suspension fully and pinches the sidewall between the rim and the obstacle. If that has happened, check both tyres on that side — the rear takes the same hit a fraction of a second after the front — and look for a bulge rather than for a hole.
We carry both outcomes to every job, so a repair that turns out not to be safe does not become a second visit.
Age and wear
Tread depth is not the only thing that retires a tyre. Rubber hardens as it ages whatever the mileage, which is why a caravan, motorhome, trailer or second car can carry almost full tread on a casing that is well past useful life. The four-digit date code on the sidewall gives the week and year it was made — our guide on how long tyres last covers where the line falls.
Depth matters most in standing water. The legal minimum is 1.6mm across the central three-quarters, but a tyre's ability to clear water falls off well above that — by about 3mm you are losing it noticeably, and aquaplaning starts at lower speeds than most drivers expect. Our tread depth guide covers checking it with a 20p coin in about a minute.
Wear patterns are worth reading too. Both outer shoulders going before the middle usually means underinflation, or a lot of cornering and hill descent; one edge alone is more often alignment. We will tell you which it looks like when we are there — see uneven tyre wear for the full picture.
Vans and light commercials
A van needs a tyre carrying the C marking and the correct load index. That is not interchangeable with a passenger tyre of the same nominal size, whatever may have been fitted before — the casing is built to carry more, and a loaded van on passenger-rated tyres is running outside the rating.
Tell us whether the van is loaded when you ring, and we will bring the right fitment first time. Details of what we carry are on the commercial tyres page.
How the repair is done
The wheel comes off, the tyre comes off the rim, and the inside of the casing is inspected before anything else happens. The puncture is then repaired from within using a combined plug and patch, and the wheel is balanced before it goes back on.
That inspection is the part that matters. An external plug pushed into the tread without removing the tyre is a get-you-home measure: it can seal the hole while leaving damage inside the casing entirely undetected, and that damage is what causes tyres to fail later at speed. It is the same job a garage does, done where the vehicle already is.
A slow leak with no puncture to find
A tyre that loses air over days with nothing in the tread has usually failed at the seal rather than the surface — a corroded alloy bead seat, or a perished valve stem. Neither can be found with the tyre still on the rim, and neither is fixed by topping the pressure up.
It typically announces itself on the first cold morning of the year. Cold air contracts, dropping the pressure a few PSI, and a leak that was tolerable through mild weather is a visibly flat tyre by the time you come out to the car. The fix is the tyre off the rim, the sealing face cleaned back to sound metal, and a new valve.
Working conditions around Haslemere
Gradients. A sustained climb builds heat in the casing, and heat finds whatever weakness is already there — which is why underinflated or previously damaged tyres are the ones that let go on a long pull rather than on the flat. On a steep slope we will ask to move onto level ground before jacking: a handbrake holds two wheels, and that margin drops sharply the moment one of them comes off the ground.
Lanes and farm access. Single-track lanes need somewhere to put both your vehicle and ours without blocking the road, so a gateway or a passing place is worth reaching if the car is still drivable. Agricultural traffic drops wire, staples and broken tines, and harvest spreads them well beyond the field gate — which is why the lanes produce punctures out of proportion to how little traffic they carry.
Station and workplace car parks. A commuter car park is where slow punctures hide. Eleven hours standing with a short drive at each end means you never drive far enough or fast enough to feel a tyre going down — so it presents as a flat at six in the evening rather than as a soft one in the morning. These are also the easiest jobs we do: the car is stationary for hours, the surface is flat, and there is room to work. Leave us the bay number and where the locking wheel nut key lives and it is finished before you are back, which beats finding it flat at the end of the day.
Common questions in Haslemere
- My tyre has gone in the Hindhead tunnel.
- Keep going and stop beyond the portal if the car will move. If it will not, use the emergency phones first — the control room can close a bore and we cannot.
- Is there a way round the tunnel?
- Not really — the old road over the Punch Bowl is closed to through traffic. That is why a soft tyre is worth sorting before you commit.
- Is the weather really different up here?
- Often. Fog sits on the ridge and ice forms on the hill roads while the valleys are clear.
- My wheel has gone off the tarmac in a sunken lane.
- Tell us. Greensand banks look solid and give way under a jack — it changes whether we can lift it where it is.
- Do you cover Hindhead, Fernhurst and Chiddingfold?
- Yes, across GU8, GU26 and GU27.
Not in Haslemere?
We cover the rest of Surrey and beyond. If you are closer to one of these, the same service and the same number applies:
- Mobile tyre fitting in Addlestone
- Mobile tyre fitting in Banstead
- Mobile tyre fitting in Camberley
- Mobile tyre fitting in Caterham
- Mobile tyre fitting in Chertsey
- Mobile tyre fitting in Cobham
- Mobile tyre fitting in Dorking
- Mobile tyre fitting in Egham
- Mobile tyre fitting in Epsom
- Mobile tyre fitting in Esher
- Mobile tyre fitting in Farnham
- Mobile tyre fitting in Godalming
Why use a mobile fitter?
You do not have to move a vehicle that is not safe to move. No limping to a garage on a space-saver, no waiting room, and no second trip to collect the car.
We bring the same equipment a garage would use, wheel balancing included, to wherever the vehicle already is.
Tyre brands we supply
We stock across three tiers so you can balance cost against tread life and wet-weather performance. If you tell us your budget, we will say honestly which tier makes sense for the mileage you do.
Budget and mid-range
- Farroad
- Hifly
- Churchill
- RoadX
- Infinity
Premium
- Michelin
- Pirelli
- Bridgestone
- Goodyear
- Continental
Need a brand that is not listed? Call us and we will check availability for your size, or search by your tyre size to see what we can fit.







