
We Come To You!
Our mobile tyre fitting service is your convenient solution
Need a tyre in Clifton?
Tell us your tyre size and where you are — we quote before we set off.

Areas We Cover
Drivers across England and Wales — maximum 60 minute response
Popular Tyre Brands Available
We supply & fit new, high-quality and branded tyres for all major vehicles









See what our customers think
Browse through our customers testimonials.
Mobile Tyre Fitting in Clifton
Clifton, the Village and the Downs - 24 hours a day.
Maximum 60 minute response. We have drivers across England and Wales, so a call gets a fitter to the vehicle rather than you moving a car that is not safe to move. Call 07989 606060 with your tyre size and location.
Clifton is the high ground west of the centre: Georgian terraces and crescents on the plateau, the shops of Whiteladies Road and Queens Road along the A4018, and several hundred acres of open grass at the Downs on its northern side.
The Clifton Suspension Bridge is the crossing from here to Leigh Woods and the Somerset side. It is privately operated, it is tolled, and it will not take every vehicle - which is a routing question for us rather than a piece of scenery.
Roads we get called to around Clifton
- Whiteladies Road and Queens Road (A4018) on the eastern side.
- Pembroke Road and Clifton Down Road.
- The Mall, Princess Victoria Street and the Village streets.
- Ladies Mile, Circular Road, Stoke Road and Upper Belgrave Road across the Downs.
- Sion Hill, the bridge approach and Bridge Valley Road.
A bridge that weighs you before it lets you across
There is a weighbridge built into the road surface on each approach to the Suspension Bridge. The limit is four tons gross or two and a half tons on any axle, and if a vehicle exceeds either figure the barriers simply stay shut. The barriers themselves take a maximum width of 2.4 metres. There is no height restriction. The toll stands at a pound a crossing, paid by contactless at the barrier, and the operator has consulted on raising it.
None of that troubles a car. It matters because a fitting van loaded with a machine, a compressor and a rack of tyres is not automatically under four tons, so we do not treat the bridge as a guaranteed route between the two sides. If your car is on the Leigh Woods side, say so when you ring: the alternative approach is a long way round, and we would rather build that into the time we quote than discover it at a locked barrier.
The Downs
The roads that run across the Downs carry free parking with no time limit, which in a district where almost everything else is permit-controlled makes them the default for anyone leaving a car for a day or a week. A good share of what we attend up here belongs to people who do not live in Clifton and cannot say much more than "on the Downs".
That is well over a mile of roadside in several directions. Ladies Mile, Circular Road, Stoke Road and Upper Belgrave Road all look alike from a car window and all have grass on both sides. Give us the road name and the nearest junction off it and we go straight there; without one we are driving the perimeter looking for a car we have only been told the colour of.
The Village and the crescents
Clifton Village is permit-controlled, one-way in places, and built as long unbroken frontages rather than as separate houses with gaps between them. Parking runs end to end along a crescent with nothing to pull into, so if your car is halfway along one there may be no way to bring a van alongside it at all. We work from wherever the van can legally stand and carry the kit to you, which is fine over twenty yards and slow over a hundred.
The other thing about these frontages is the basement area behind railings at the pavement edge. It means the footway side of the car gives you nothing to step into, so all the working room is on the carriageway side. Tell us what is parked in front and behind and we will know before setting off whether this is a five-minute job or a shuffle.
We are along Whiteladies Road in Redland most days, up the hill from Kingsdown, and across Bristol generally.
What we can do in Clifton
- Mobile tyre fitting — supply and fit a replacement at your home, workplace or the roadside, including balancing and disposal of the old casing.
- Mobile puncture repair — where the damage is inside the repairable area of the tread, a repair is cheaper and quicker than replacement.
- Commercial tyre fitting — vans, minibuses and other light commercial vehicles.
Stuck in Clifton right now? Call 07989 606060 and we will tell you what we can do and what it will cost before we set off.
Before we arrive
- Find your locking wheel nut key. Without it the wheel cannot come off. It is usually in the glovebox, the boot well, or with the spare.
- Read your tyre size off the sidewall, for example 205/55 R16 91V, so we arrive with the right tyre rather than making a second trip.
- If you are on a motorway or dual carriageway, get as far left as you can or into a refuge, then everyone out through the passenger doors, over the barrier and well back from the carriageway — not in the car. Ring with the junction number and your direction of travel.
- Describe where you are, not just your postcode. A junction number, a bay number, a farm, a pub or a bridge puts us on the spot far faster — rural postcodes can cover a mile of near-identical lane. We bring our own lighting, so darkness is not a problem.
More detail in our guides on what to do with a flat tyre on the motorway and checking your tread depth.
Repair or replace
Whether a tyre can be repaired is decided by where the damage is, not by how big the hole looks. Damage inside the central three-quarters of the tread, up to 6mm across, is repairable under BS AU 159. Damage in the shoulder or the sidewall is not, at any size — there is no way to reinforce a sidewall that flexes on every revolution.
The other thing that rules out a repair is having driven on the tyre flat. A short distance is enough: the sidewall folds under the rim and the internal cords break. That often does not deflate the tyre at the time — it shows up days later as a soft rounded bulge, and a tyre in that condition has to be replaced whatever the original puncture looked like.
How the damage was made matters as much as where it is. A nail or a screw pierces, leaving a neat hole that is usually well within the limit. Flint, crushed stone, quarry aggregate and dropped stainless fixings cut instead — a gouge or a tear rather than a puncture — and a cut frequently exceeds the repairable size even when it lands squarely in the middle of the tread. That is why we take the tyre off and look inside before telling you either way, rather than judging it from the outside.
Impact damage behaves the same way. A pothole or a kerb taken at speed compresses the suspension fully and pinches the sidewall between the rim and the obstacle. If that has happened, check both tyres on that side — the rear takes the same hit a fraction of a second after the front — and look for a bulge rather than for a hole.
We carry both outcomes to every job, so a repair that turns out not to be safe does not become a second visit.
Age and wear
Tread depth is not the only thing that retires a tyre. Rubber hardens as it ages whatever the mileage, which is why a caravan, motorhome, trailer or second car can carry almost full tread on a casing that is well past useful life. The four-digit date code on the sidewall gives the week and year it was made — our guide on how long tyres last covers where the line falls.
Depth matters most in standing water. The legal minimum is 1.6mm across the central three-quarters, but a tyre's ability to clear water falls off well above that — by about 3mm you are losing it noticeably, and aquaplaning starts at lower speeds than most drivers expect. Our tread depth guide covers checking it with a 20p coin in about a minute.
Wear patterns are worth reading too. Both outer shoulders going before the middle usually means underinflation, or a lot of cornering and hill descent; one edge alone is more often alignment. We will tell you which it looks like when we are there — see uneven tyre wear for the full picture.
Vans and light commercials
A van needs a tyre carrying the C marking and the correct load index. That is not interchangeable with a passenger tyre of the same nominal size, whatever may have been fitted before — the casing is built to carry more, and a loaded van on passenger-rated tyres is running outside the rating.
Tell us whether the van is loaded when you ring, and we will bring the right fitment first time. Details of what we carry are on the commercial tyres page.
How the repair is done
The wheel comes off, the tyre comes off the rim, and the inside of the casing is inspected before anything else happens. The puncture is then repaired from within using a combined plug and patch, and the wheel is balanced before it goes back on.
That inspection is the part that matters. An external plug pushed into the tread without removing the tyre is a get-you-home measure: it can seal the hole while leaving damage inside the casing entirely undetected, and that damage is what causes tyres to fail later at speed. It is the same job a garage does, done where the vehicle already is.
A slow leak with no puncture to find
A tyre that loses air over days with nothing in the tread has usually failed at the seal rather than the surface — a corroded alloy bead seat, or a perished valve stem. Neither can be found with the tyre still on the rim, and neither is fixed by topping the pressure up.
It typically announces itself on the first cold morning of the year. Cold air contracts, dropping the pressure a few PSI, and a leak that was tolerable through mild weather is a visibly flat tyre by the time you come out to the car. The fix is the tyre off the rim, the sealing face cleaned back to sound metal, and a new valve.
Common questions in Clifton
- Can your van come over the Suspension Bridge to reach me?
- Not as a given. The approaches weigh the vehicle and lock the barriers above four tons gross or two and a half tons per axle, so we plan the route round rather than assuming it.
- I am parked on the Downs. What do you need from me?
- The road name and the nearest turning. "The Downs" covers more than a mile of near-identical grass verge on several different roads.
- My car is mid-crescent with cars nose to tail either side.
- Then the van stands at the nearest legal space and we carry in. Say roughly how far along the crescent you are so we know which end to come from.
- Is there anywhere to work outside a house with a basement area?
- Only on the road side. The railings mean the pavement gives nothing, so the space in front of and behind the car is what decides it.
- Do you cover Hotwells, Clifton Wood and Cotham?
- Yes, right across BS8 and into BS6.
Not in Clifton?
We cover the rest of Bristol and beyond. If you are closer to one of these, the same service and the same number applies:
- Mobile tyre fitting in Almondsbury
- Mobile tyre fitting in Arnos Vale
- Mobile tyre fitting in Avonmouth
- Mobile tyre fitting in Barton Hill
- Mobile tyre fitting in Bedminster
- Mobile tyre fitting in Bishopston
- Mobile tyre fitting in Bishopsworth
- Mobile tyre fitting in Bradley Stoke
- Mobile tyre fitting in Brentry
- Mobile tyre fitting in Brislington
- Mobile tyre fitting in Bristol
- Mobile tyre fitting in Chipping Sodbury
Why use a mobile fitter?
You do not have to move a vehicle that is not safe to move. No limping to a garage on a space-saver, no waiting room, and no second trip to collect the car.
We bring the same equipment a garage would use, wheel balancing included, to wherever the vehicle already is.
Tyre brands we supply
We stock across three tiers so you can balance cost against tread life and wet-weather performance. If you tell us your budget, we will say honestly which tier makes sense for the mileage you do.
Budget and mid-range
- Farroad
- Hifly
- Churchill
- RoadX
- Infinity
Premium
- Michelin
- Pirelli
- Bridgestone
- Goodyear
- Continental
Need a brand that is not listed? Call us and we will check availability for your size, or see how mobile tyre fitting works.







